Drip edge installation
The metal at the roof edge
Attic ventilation works as a pair: intake low at the soffits, exhaust high at the ridge. Get the balance wrong — or block the intake with insulation pushed into the eaves — and the roof space stops breathing. The result shows up as condensation on the underside of the decking, as shortened shingle life from trapped heat, and in colder parts of the state as ice damming, because a warm roof melts snow that then refreezes over the cold overhang. A lot of apparent leaks are actually ventilation problems.
Twiggs County sits in Georgia's hail belt, where the spring storm line coming across the state tends to organise. Hail is the dominant roof killer here and it works slowly: the stone bruises the asphalt mat under the granule surface without breaking through, so the roof keeps water out for another season or two and then starts leaking from spots that were damaged years earlier. Add the summer heat load — Twiggs County roofs run extremely hot, which ages the shingle and dries out the sealant around every penetration — and the failures cluster around pipe boots, flashing and anything with a rubber component.
Routinely. Condensation forming on cold decking drips onto insulation and shows up as damp patches that behave almost exactly like ingress. The tell is that it tracks cold weather rather than rain.
No. Mixing exhaust types — ridge vents and powered fans, say — can make a fan pull air from the ridge instead of the soffits, which short-circuits the whole system. Balance between intake and exhaust matters more than total area.
The metal at the roof edge
The capping along the roof peak
Crown, cap and masonry
Lifted tabs and broken seals
Vinyl, fiber cement and wood
Lifting panels for roof work
You will get a straight answer on whether Twiggs County needs someone out today or whether it can wait — before anyone quotes you for anything.
Call (229) 235-1425